SunSaver MPPT
Objects and Definitions
Data
This is the complete list of data objects that can be accessed using the Data
dropdown on the dashboard
Object | Description | Type | Symbol |
---|---|---|---|
Adc_vb_f |
Nominal Battery Voltage | volts | V |
Adc_va_f |
"Array voltage, filtered (τ ≈ 1s)" | volts | V |
Adc_vl_f |
"Load voltage, filtered (τ ≈ 1s) " | volts | V |
Adc_ic_f |
"Charging current, filtered (τ ≈ 1s)" | amps | A |
Adc_il_f |
"Load current, filtered (τ ≈ 1s)" | amps | A |
T_hs |
Heatsink temperature | celsius | °C |
T_batt |
Battery temperature | celsius | °C |
T_amb |
Ambient temperature | celsius | °C |
T_rts |
Remote battery temperature sensor | celsius | °C |
charge_state |
Charge state | string | |
array_fault |
Array Faults | array | |
Vb_f |
"Battery voltage, slow filter (τ ≈ 25s)" | volts | V |
Vb_ref |
Battery regulator reference voltage | volts | V |
Ahc_r |
Ah charge resetable | amp-hours | Ah |
Ahc_t |
Ah charge total | amp-hours | Ah |
kWhc |
kWh charge | kilowatt-hours | kWh |
load_state |
Load state | string | |
load_fault |
Load faults | array | |
V_lvd |
load current compensated LVD voltage | volts | V |
Ahl_r |
Ah load resetable | amp-hours | Ah |
Ahl_t |
Ah Load Total | amp-hours | Ah |
hourmeter |
Hourmeter | hours | h |
alarm |
Alarm Bitfield | array | |
dip_switch |
dip Switch Settings at Power On | array | |
led_state |
SOC LED state | string | |
Power_out |
Charge output power | watts | W |
Sweep_Vmp |
Array Vmp found during sweep | volts | V |
Sweep_Pmax |
Arrap Pmax(output) found during sweep | watts | W |
Sweep_Voc |
Array Voc found during sweep | volts | V |
Vb_min_daily |
Vb minimum voltage – daily | celsius | °C |
Vb_max_daily |
Vb maximum voltage – daily | string | |
Ahc_daily |
Ah charge - daily | amp-hours | Ah |
Ahl_daily |
Ah load - daily | amp-hours | Ah |
array_fault_daily |
Array faults daily | array | |
load_fault_daily |
Load faults daily | array | |
alarm_daily |
Alarms daily | array | |
vb_min |
minimum battery voltage | volts | V |
vb_max |
maximum battery voltage | volts | V |
lighting_should_be_on |
"In lighting mode, if non-zero, the light output should be on" | integer | |
va_ref_fixed |
fixed Vmp if set | volts | V |
va_ref_fixed_pct |
Vmp = % of Voc if set | percentage | % |
EV_reg |
Regulation voltage @ 25ºC | volts | V |
EV_float |
Float voltage @ 25ºC | volts | V |
Et_float |
time before entering float | seconds | s |
Et_floatlb |
time before entering float due to low battery | seconds | s |
EV_floatlb_trip |
Voltage that triggers low battery float time | volts | V |
EV_float_cancel |
Voltage that cancels float | volts | V |
Et_float_exit_cum |
time before exiting float | seconds | s |
EV_eq |
Equalize voltage @ 25ºC | seconds | s |
Et_eqcalendar |
days between eq cycles | days | |
Et_eq_above |
equalize time limit above Vreg | seconds | s |
Et_eq_reg |
equalize time limit at Veq | seconds | s |
EV_reg2 |
Regulation voltage @ 25ºC | volts | V |
EV_float2 |
Float voltage @ 25ºC | volts | V |
Et_float2 |
time before entering float | seconds | s |
Et_floatlb2 |
time before entering float due to low battery | seconds | s |
EV_floatlb_trip2 |
Voltage that triggers low battery float time | volts | V |
EV_float_cancel2 |
Voltage that cancels float | volts | V |
Et_float_exit_cum2 |
time before exiting float | seconds | s |
EV_eq2 |
Equalize voltage @ 25ºC | seconds | s |
Et_eqcalendar2 |
days between eq cycles | days | |
Et_eq_above2 |
equalize time limit above Vreg | seconds | s |
Et_eq_reg2 |
equalize time limit at Veq | seconds | s |
EV_tempcomp |
LSB only | volts | V |
EV_hvd |
High Voltage Disconnect @ 25ºC | volts | V |
EV_hvr |
High Voltage Reconnect | amps | A |
Evb_ref_lim |
Maximum charge reference (0 disables) | volts | V |
ETb_max |
Max battery temp compensation limi | celsius | °C |
ETb_min |
Min battery temp compensation limi | celsius | °C |
EV_lvd |
Low Voltage Disconnect | volts | V |
EV_lvr |
Low Voltage Reconnect | volts | V |
EV_lhvd |
Load High Voltage Disconnect | volts | V |
EV_lhvr |
Load High Voltage Reconnect | volts | V |
ER_icomp |
LVD Load current compensation | ohms | Ω |
Et_lvd_warn |
LVD warning timeout | seconds | s |
EV_soc_y2g |
LED yellow to green limit | volts | V |
EV_soc_g2y |
LED green to yellow limit | volts | V |
EV_soc_y2r0 |
LED yellow to blinking red | volts | V |
EV_soc_r2y |
LED red to yellow limit | volts | V |
Emodbus_id |
Modbus ID | integer | |
Emeter_id |
meter bus ID | integer | |
EVa_ref_fixed |
fixed Vmp if set (overrides % if both set) | volts | V |
EVa_ref_fixed_pct |
Vmp = % of Voc if set (0 or 0xff disables) | percentage | % |
Eic_lim |
Charge current limit (into battery) | amps | A |
Ehourmeter |
Hourmeter | hours | h |
EAhl_r |
Ah Load Resettable | amp-hours | Ah |
EAhl_t |
Ah Load Total | amp-hours | Ah |
EAhc_r |
Ah Charge Resettable | amp-hours | Ah |
EAhc_t |
Ah Charge Total | amp-hours | Ah |
EkWhc |
kWhc Resettable | kilowatt-hours | kWh |
EVb_min |
Battery Voltage Minimum | volts | V |
EVb_max |
Battery Voltage Maximum | volts | V |
EVa_max |
Array Voltage Maximum | volts | V |
Etmr_eqcalander |
Equalize calendar timer | days |
Action
Object | Description |
---|---|
eq |
Trigger equalize charge |
load_on |
Turn load on |
load_off |
Turn load off |
charge_on |
Turn charge on |
charge_off |
Turn charge off |
Ah_r |
Reset Ah resettable |
Ah_t |
Reset Ah total |
kWh_r |
Reset kWh resettable |
EEPROM |
Reset EEPROM |
light_test |
Lighting Mode Test - when lighting mode is enabled turns on load output for 10 minutes |
reset |
Reset controller |
2 Hour Logs
These objects are logged every 2 hours.
Objects:
Power_out
Adc_vb_f
Adc_va_f
Adc_vl_f
Adc_il_f
T_hs
T_amb
Daily Logs
These objects are logged once every day.
Objects:
kWhc
Vb_min_daily
Vb_max_daily
Ahc_daily
Ahl_daily
Va_max_daily
Alerts
These objects are scanned every few seconds and alerts will be sent as soon as any critical issues are detected.
Objects:
load_state
charge_state
array_fault
load_fault
alarm